Bayou City Water Restoration

MOLD REMEDIATION

Mold Remediation in Katy & west Houston, TX

Mold remediation removes mold growth and fixes the moisture that fed it. Owner Neil Walker holds Texas Mold Remediation Contractor license MRC2338, and we work to a licensed assessor's written protocol and the IICRC S520 standard.

Founded 2023 · Insured · Open 24 hours

Drag to see before and after

The same living room fully dry and restoredLiving room with two inches of standing water on the hardwood floor at dawn
Illustration — not an actual job
IICRC Standard
S520
Typical timeline
Set by the licensed mold assessor's written protocol
Insurance coverable
Varies — call us

Licensed in Texas. Owner Neil Walker holds Texas Mold Remediation Contractor license MRC2338, issued by the Texas Department of Licensing and Regulation (TDLR). You can look it up on the TDLR license search.

Mold is a water problem first

Mold needs moisture to grow. Remove the mold without fixing the water, and it comes back. The EPA says mold can start growing on wet materials within 24 to 48 hours. That is why every mold job we do starts with a moisture meter, not a spray bottle.

A real Katy job: the musty guest bathroom

A slow leak from an attic HVAC unit ran into the guest bathroom below it for what looked like years. The drain line was not designed right. The only signs were a musty smell and a patch of mold under the sink.

Our moisture meter showed high readings in the ceiling, all four walls, and some of the walls next to the bathroom. That pattern means the problem lives behind the drywall. So we gave the homeowner the blueprint: bring in a licensed mold assessor, get the protocol in writing, then the work, then the clearance test.

The assessor’s protocol called for containment around the bathroom, negative air pressure with an air scrubber, and the bathroom taken to the studs: tub, sink, toilet, drywall, ceiling and flooring. We did the remediation to that protocol. The assessor came back, ran the clearance test, and it passed.

Then we rebuilt it the way she wanted: a tiled walk-in shower instead of the tub, new tile, flooring, sink and cabinet, drywall and paint.

Read the full story

The Texas rules that protect you

Our process

  1. Find the water. Meter readings and the source.
  2. Protocol. An independent licensed assessor writes it.
  3. Contain. Plastic barriers, negative air, HEPA air scrubbers.
  4. Remove. Materials with mold growth come out.
  5. Clean. HEPA vacuum and wipe the surfaces that stay.
  6. Dry. To a verified dry standard.
  7. Clearance. The assessor tests, and it must pass.
  8. Certificate. Within 10 days.
  9. Rebuild. We put the room back.

Where mold starts in Gulf Coast homes

If you see mold

Do:

Don’t:

Will insurance cover it?

It depends on your policy and what caused the mold. Ask your carrier what your policy says about mold. Either way, the protocol, clearance report and certificate document the job.

Where we work

Dispatched from Katy across Katy, Fulshear, Cinco Ranch, Richmond, Sugar Land, Cypress, and Houston.

When it comes to your home, every detail matters.

FAQ

Will my homeowners insurance cover water damage restoration?
Most homeowners policies cover sudden and accidental water damage — a burst pipe, an overflowing dishwasher, an ice-maker line that lets go overnight. What is typically excluded is flooding from outside the home (storms, rising creeks), which requires a separate NFIP or private flood policy. We document everything to your carrier's standard and bill your insurance directly when the loss is covered.
Call 24/7 — (832) 862-8685